If you own a Whirlpool WRS325FDAB02 refrigerator, you may know that it comes with a built-in water filtration system that helps to reduce impurities and contaminants from your drinking water and ice. However, over time, the filter may get clogged or expire, which can affect the quality and taste of your water. Therefore, it’s important to replace the Whirlpool WRS325FDAB02 water filter periodically, usually every 6 months, or as needed based on your water usage and quality.
In this article, we’ll explain how to replace the Whirlpool WRS325FDAB02 water filter in a few easy steps. By following these instructions, you can ensure that your refrigerator continues to provide clean and fresh water for you and your family.
Step 1: Purchase the Correct Water Filter
Before you start the replacement process, you need to obtain the right water filter for your Whirlpool WRS325FDAB02 refrigerator. The compatible water filter model for this fridge is the Whirlpool EDR1RXD1, also known as Filter 1. You can buy it online or in-store from Whirlpool, Amazon, or other authorized dealers.
Step 2: Turn Off the Water Supply
To avoid any leaks or spills, you should turn off the water supply to your refrigerator. Locate the shut-off valve behind your fridge or under the sink and turn it clockwise until it’s closed.
Step 3: Remove the Old Water Filter
Open the fridge door and locate the filter compartment on the lower left side. Press the eject button next to the filter and pull it out gently. If the filter is stuck, you may need to twist it counterclockwise and then pull it out. Place the old filter aside and dispose of it properly.
Step 4: Install the New Water Filter
Unpack the new water filter from its packaging and remove the protective cap. Align the arrow on the filter with the arrow on the filter compartment and insert the filter into the slot. Push it in firmly until it clicks into place. If the filter doesn’t click, it may not be installed correctly.
Step 5: Flush the Water System
After you install the new water filter, you need to flush the water system to remove any air or debris that may be trapped inside. Hold a cup under the water dispenser and press the dispenser lever for 5-10 minutes or until the water runs clear. You may need to repeat this step several times to get rid of all the bubbles.
Step 6: Reset the Water Filter Status
To ensure that your Whirlpool WRS325FDAB02 fridge recognizes the new filter, you need to reset the water filter status. Press and hold the “Filter Reset” button for 3-5 seconds or until the indicator light changes from red to green. This will clear the “Replace Filter” reminder and set it to the next scheduled replacement time.
Step 7: Turn On the Water Supply
Finally, you can turn on the water supply to your refrigerator by turning the shut-off valve counterclockwise. Check for any leaks or drips around the filter and the water line. If you notice any, tighten the connections or call a professional for assistance.
Conclusion
Replacing the Whirlpool WRS325FDAB02 water filter is a simple and necessary maintenance task that can improve the quality and safety of your drinking water. By following the above steps, you can replace the filter in less than 10 minutes and enjoy clean and fresh water for the next few months. Don’t forget to mark your calendar or set a reminder for the next replacement date to ensure optimal
